Grille roll-up, aluminium, anodized natur
Grille for trench convector
The grilles are the only visible element of the trench convectors, which is why we offer a wide range of materials and designs.
Technical information:
- the height of the grille is 20 mm
- the rings between the slats are made of aluminium
- the distance between the slats is 12 mm
- there is a spring inside
- widths we offer fit our convectors. In case you are replacing a competitor's grille, the actual width of the PMO grille is 6 mm shorter.
Basic materials:
- anodized aluminium
- oak
- beech
- interior stainless steel
Basic categorization of grilles:
- grille without decorative strip
- grille with decorative strip
The PMO grille without decorative strip is ideal for areas where the finished floor is perfectly laid (equal width of the gap between the edge of the convector and the finished floor).
The PMU grille with decorative strip is ideal if you want the edge of the convector to be covered. Perfectly laid finished floor is a prerequisite. The strip (U-frame) is delivered pre-cut together with the grille.
The PML grille with decorative strip is ideal for covering uneven gaps between the edge of the convector and the finished floor. The strip (L-frame) is delivered pre-cut together with the grille.
The PMZ grille with decorative strip is only used in situations where the tray of the convector is "sunk" below the finished floor level. In this case, the Z-frame has to be supported from below (placed on something). The Z-frame is delivered already assembled including the grille.
